AL14700GBBTAL14700GBBT, alarmy, schematy pl
[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00 www.cobra.it MAKE ALFA ROMEO MOD. 147* YEAR. 00 fi PETROL DIESEL X * Models with original equipment keyless entry system. ALARM/SIREN POSITION Position the compact alarms and the sirens on the support of the servobrake in the engine compartment. CENTRAL UNIT POSITION The modular systems and the modules should be positioned under the dashboard, driver’s side. POWER SUPPLY +30: connect to the positive end of the battery. -31: connect directly to the car body. IGNITION WIRE +15/54: Connect to the 2 mm 2 ORANGE wire located in the wiring harness coming out of the connector of the ignition key. DIRECTION INDICATORS The electric system of the car has the direction indicators lines divided, so it is suggested to divide the wires of the direction indicators ant. and post. by means of 4 diodes: LIGHT BROWN/BLACK (ant. left), BROWN/VIOLET (ant. right), BROWN/WHITE (lat. left), BROWN/YELLOW (lat. right), these wires are located in the 40 way light blue connector and BROWN/BLACK (post. left), BROWN/VIOLET (post. right) are located in the 40 way black connector in the fuse box. Note: do not put the diodes on the lines of the lateral direction indicators. ELECTRIC WINDOWS Positive control signal Front window, driver’s side: cut the the 1 mm 2 GREY wire located in the 26 way connector inside the driver’s side door. Front window, passenger’s side: cut the 1 mm 2 VIOLET/BLACK wire located in the wiring harness behind the sill cover driver’s side. ACTIVAT./DEACTIVATION CONTROLS Connections antitheft/vehicle Art.3800 Vehicle Position YELLOW/BLACK GREEN/YELLOW coming out driver’s side door GREY/BLACK GREEN/GREY coming out driver’s side door VIOLET BROWN/YELLOW 40 way connector (direc. indic.) ORANGE Ground car body VIOLET/WHITE Ground car body ORANGE/WHITE Ground car body Note: to program activation and deactivation controls of the antitheft DO NOT USE the door contact control as there are negative signals not usable for programming. IMMOBILISATION POINT Fuel pump Cut the 2 mm 2 VIOLET/YELLOW wire located in the bundle of cables behind the sill cover, driver’s side. STARTER +50: Cut the BROWN wire located in the wiring harness coming out of the ignition key. BONNET SWITCH Install an additional switch on the front headlamp support grill, driver’s side. DOORS SWITCH Connect to the LIGHT BLUE/YELLOW wire located in the wiring harness coming out of the lamp. BOOT SWITCH Connect to the BROWN/GREY wire coming out of the boot lamp. Note: for the programming of the antitheft (activation and deactivation controls) use the boot control. Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed as per the instructions given on the product installation manual. al14700gbbt.doc [ Pobierz całość w formacie PDF ] |
Podobne
|