, ALTO GATE (EN), INSTRUKCJE OBSŁUGI SPRZĘTU, PO ANGIELSKU (EN) 

ALTO GATE (EN)

ALTO GATE (EN), INSTRUKCJE OBSŁUGI SPRZĘTU, PO ANGIELSKU (EN)
[ Pobierz całość w formacie PDF ]
User's Manual
ALTO GATE
EXPANDER/GATE
LTO
R
www.altoproaudio.com
Version 1.3 September 2005
English
SAFETY RELATED SYMBOLS
Fuse
To prevent fire and damage to the product, use only
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
the recommended fuse type as indicated in this
manual. Do not short-circuit the fuse holder. Before
replacing the fuse, make sure that the product is
OFF and disconnected from the AC outlet.
This symbol, wherever used, alerts you to the pre-
sence of un-insulated and dangerous voltages with-
in the product enclosure. These are voltages that
may be sufficient to constitute the risk of electric
shock or death.
Protective Ground
Before turning the product ON, make sure that it is
connected to Ground. This is to prevent the risk of
electric shock.
Never cut internal or external Ground wires. Likewise,
never remove Ground wiring from the Protective
Ground Terminal.
This symbol, wherever used, alerts you to impo-
rtant operating and maintenance instructions.
Please read.
Protective Ground Terminal
Operating Conditions
AC mains (Alternating Current)
Always install in accordance with the manufacturer's
instructions.
To avoid the risk of electric shock and damage, do
not subject this product to any liquid/rain or moisture.
Do not use this product when in close proximity to
water.
Do not install this product near any direct heat source.
Do not block areas of ventilation. Failure to do so
could result in fire.
Keep product away from naked flames.
Hazardous Live Terminal
ON:
Denotes the product is turned on.
OFF:
Denotes the product is turned off.
WARNING
Describes precautions that should be observed to
prevent the possibility of death or injury to the user.
CAUTION
Describes precautions that should be observed to
prevent damage to the product.
IMPORTANT SAFETY INSTRUCTIONS
Disposing of this product should not be
placed in municipal waste and should be
Separate collection.
Read these instructions
Follow all instructions
Keep these instructions. Do not discard.
Heed all warnings.
Only use attachments/accessories specified by the
manufacturer.
WARNING
Power Supply
Ensure that the mains source voltage (AC outlet)
matches the voltage rating of the product. Failure
to do so could result in damage to the product and
possibly the user.
Unplug the product before electrical storms occur
and when unused for long periods of time to reduce
the risk of electric shock or fire.
Power Cord and Plug
Do not tamper with the power cord or plug. These are
designed for your safety.
Do not remove Ground connections!
If the plug does not fit your AC outlet seek advice from
a qualified electrician.
Protect the power cord and plug from any physical
stress to avoid risk of electric shock.
Do not place heavy objects on the power cord. This
could cause electric shock or fire.
External Connection
Always use proper ready-made insulated mains
cabling (power cord). Failure to do so could result
in shock/death or fire. If in doubt, seek advice from
a registered electrician.
Cleaning
Do Not Remove Any Covers
Within the product are areas where high voltages
may present. To reduce the risk of electric shock do
not remove any covers unless the AC mains power
cord is removed.
Covers should be removed by qualified service
personnel only.
When required, either blow off dust from the product
or use a dry cloth.
Do not use any solvents such as Benzol or Alcohol.
For safety, keep product clean and free from dust.
Servicing
Refer all servicing to qualified service personnel only.
Do not perform any servicing other than those instruc-
tions contained within the User's Manual.
No user serviceable parts inside.
1
PREFACE
Dear Customer:
Thanks for choosing LTO GATE and thanks for choosing one of the results of LTO AUDIO TEAM job and
researches.
For our LTO AUDIO TEAM, music and sound are more than a job... are first of all passion and let us say... our
obsession!
We have been designing professional audio products for a long time in cooperation with some of the major brands in
the world in the audio field.
The LTO line presents unparalleled analogue and digital products made by Musicians for Musicians in our R&D
Centers in Italy, Netherlands, United Kingdom and Taiwan. The core of our digital audio products is a sophisticated
DSP (Digital ound rocessor) and a large range of state of the art algorithms which have been developed by our
Because we are convinced you are the most important member of LTO AUDIO TEAM and the one confirming the
quality of our job, we like to share with you our work and our dreams, paying attention to your suggestions and your
comments.
Following this idea we create our products and we will create the new ones! From our side, we guarantee you and we
will guarantee you also in future the best quality, the best fruits of our continuous researches and the best prices.
Our LTO GATE is the result of many hours of listening and tests involving common people, area experts, music-
ians and technicians.
The results of this effort is that you can acquire an extremely efficient and universal dynamics processor. It Contains
several new circuits design which make the unit an ultimate dynamic processor: interactive Expander/Gate and super
low distortion VCA (Voltage Controlled Amplifier).
Nothing else to add, but that we would like to thank all the people that made the LTO GATE a reality available to
our customers, and thank our designers and all the LTO staff, people who make possible the realization of products
containing our idea of music and sound and are ready to support you, our customers, in the best way, conscious that
you are our best richness.
Thank you very much.
LTO AUDIO TEAM
2
SP
Software Team for the last 7 years.
TABLE OF CONTENTS
1. INTRODUCTION........................................................................................................................................4
2. THE CONCEPT BEHIND.........................................................................................................................4
2.1 Some Technical Stuff
2.2 Voltage Controlled Amplifier (VCA)
2.3 Inputs
3. CONTROLS................................................................................................................................................6
3.1 The Front Panel
3.2 The Rear Panel
4. INSTALLATION AND CONNECTION.......................................................................................................8
5.1 Mains Connection
5.2 Audio Connection
5.3 Rack Mounting
5. TECHNICAL SPECIFICATIONS .................................................................................................................................11
6. BLOCK DIAGRAM .....................................................................................................................................................12
7. WARRANTY ...............................................................................................................................................................13
3
1. INTRODUCTION
You are now the owner of an LTO GATE. Your LTO GATE is based on many years of experience and is designed
to eliminate noise in systems, hiss and hum in amplifiers, surrounding noise and so on. For more information, please
read this manual carefully.
Feature List:
Mountable in one standard 19" rack unit
Illuminated power switch
Manually adjustable HOLD and RELEASE time
Indicating gain attenuation with 8-segment LED
Range control for gate mode while ratio for expander mode
Balanced XLR and 1/4" TRS connectors for inputs and outputs
Side-chain Filter
The adjustable parametric side-chain filter allows the user to select and eliminate certain frequencies that may
result in unwanted triggering of the gate and expander.
The EXPANDER/GATE Section
You can select freely the EXPANDER/GATE mode in your unit. The two modes can reduce or cut-off the level
of audio signal below a certain set threshold to avoid unexpected noise.
Super quality parts and rigid configuration for long life and full credibility
2. THE CONCEPT BEHIND
2.1 Some Technical Stuff
Good old analog technology: It will allow us to manufacture audio equipment with a very high dynamic range: up
to 125 dB. But the dynamic range of digital equipment is more or less 25 dB less. A further reduction in dynamic
range occurs with the use of tape recorders and/or vinyl records.
2.1.1 It is not just Music
Yes, a piece of electronic will produce some noise. When the current flows through a conductor this will
generate a certain movement of the electrons and therefore: noise. And throughout the whole spectrum of
audio. Imagine what happens when this inherent noise will be amplified. Yes, today one can use "low-noise"
components but still such components will present a certain level of residual noise.
For example with tape recorders it will not be possible to get an S/N (signal to noise) ratio better than 70dB.
This level would not be accepted today by the increased sensitivity of the Listeners. It is possible to improve
the performance of a tape recorder: Absolutely no!
2.1.2 Introducing Audio Dynamics
The human ear can detect the noise generating by falling leaves as well as the roar generated by the taking
off space shuttle. Unfortunately no analog, nor digital device can reproduce such wide spectrum. Please look
at Chart. 1 and you will see the difference if dynamic capacity of various devices when compare to the human
ear. More problems occur when handling high level signals and low level signals. When you reach the high
level limit you may incur in distortion because of the dynamic range of the instrument therefore a certain
"reserve" must be maintained to avoid distortion.
This reserve is known as "headroom" and it is usually set at 10 20 dB. Would not be easier just to reduce
the operating level? Yes, it would. But you would put low level music signals at the same level of the basic
noise floor so the overall quality of the signal would be highly deteriorated. Please look at Chart. 2 and note
the Usable dynamic range (including headroom) versus high level distortion generated by peaks, and Noise
floor level.
4
[ Pobierz całość w formacie PDF ]
  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • dodatni.htw.pl